ASVAB Auto and Shop Practice Test 1

If your car has a fuel injection system, which of the following will it not need?

Which component distributes high voltage to the spark plugs?

Which type of bolt is has a square section that grips into the part being fixed (typically wood) to prevent the bolt from turning when the nut is tightened?

What is the correct sequence of a four-stroke cycle gas engine?

Which would be the last woodworking plane that you would use to prepare a rough sawn board for finishing?

Which type of wrench is used to turn screw or bolt heads designed with a hecagonal socket (recess) to receive the wrench?

The best way to sand the end grain of wood is?

Which type of saw is best used for cutting small, often awkward features in building materials such as drywall?

Which component controls the amount of current that the alternator sends to the battery?

Which of the following will NOT occur from setting a spark plug gap wider?

What should you do if your temperature gauge on your car indicates that the car is overheating (in the red zone)?

Which of the following can cause water sludge in engine crankcase oil?

Which of the following components prevents a car’s battery from being overcharged?

Which of the following is probably NOT a cause of an engine overheating?

When you try and start an engine, you hear a clicking sound but nothing happens. What is the potential problem?

What type of wrench is pictured?

What type of clamp is this?

Which type of saw is designed to make accurate crosscuts at specific angles?

On a woodworking plane, the “frog” refers to the

What tool is used by electricians to route new wiring through walls?